Has anybody re-located their ignition switch

[ARCIE31]

I am looking at re-locating my ignition switch.
Has anybody done it.
Where do you think would be best.
I thought of the infills on the frame close to the subframe mounts.
will it affect the strength though and will there be enough room at the rear.
It may be it has to stay where it is
Just a thought can it be replaced by a keyless system (button/switch for on, button/switch for off)
Suggestions greatly accepted.
Cheers
ARCIE31

[jaysun0ne]

i just got a 1/4 turn throtle from hord and realized yesterday i will need to relocate the kill switch and starter button. i was going to just trying to wire in a toggle switch and a push button on my instrument cluster. im just not sure what wires do what theres like 4 wires going to the starter button. kill switch should be easy.


a thought that crossed my mind is the location of the kill switch, when its on the bar its easy and quik to get to. if you move it what happens when you need to cut power to the motor really fast, you will need to move your hand loose a lot of time. thats why im going to keep it has close to my hands has possable.

[ARCIE31]

Point taken
ARCIE31

[TJStoner]

i used a 900rr start/ stop switch w/ the RC51 throttle...have not wired it up yet...but it seems to be the ticket

[Kilter]

anyone know what wires you need to keep/use for a keyless ignition? I'm going to want to ditch the whole switch on the track bike