Announcement

Collapse
No announcement yet.

Canyon Chasers 3rd Washer? (Cush Drive)

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • Canyon Chasers 3rd Washer? (Cush Drive)

    Hey I’m back again hoping for some quick help. I’m replacing my Cush rubbers today following the canyon chasers instructions that I have seen recommended on the forum. I can’t seem to get the hub off the axel. They mentioned a 3rd “thicker” washer that centers the hub. I’m assuming that’s what I have pointed to in the pic. I can’t find a way to get it off and the hub is still held on. What am I not doing right? Should I take it off the center stand to put some load back on it?
    You do not have permission to view this gallery.
    This gallery has 1 photos.

  • #2
    Does it move at all? Have you tried a little persuasion... Usually they come off pretty easy, but I've had some that just don't want to let go.
    Don't spend money and buy, spend time and learn.

    Comment


    • #3
      yea that looks like it. its about 1/4 inch thick. maybe giver her a few light love taps/brass brush for old times sake

      Comment


      • #4
        Originally Posted by 6
        Does it move at all? Have you tried a little persuasion... Usually they come off pretty easy, but I've had some that just don't want to let go.
        It would just slightly move but something was holding on to it pretty good. A few good whacks from behind changed its mind lol. The rubbers were in there alright. Reduced to a thick sticky paste on and in between everything. It behaves so much better now. Happy bike happy life am I right?

        Comment

        Working...
        X
        😀
        🥰
        🤢
        😎
        😡
        👍
        👎