Hawk GT Rear Sets

[J-Rod10]

Rear Sets
Got the shift side wrapped up. They're done.
Have had quite a few people message to ask if these will be available to buy.
Will do ten sets, between the Hawk forum and the Hawk FB page, at $275 + shipping. After those, they'll be a bit pricier.
Kit includes:
Brackets
Controls
Linkage for the shift side
Splined piece for the shift shaft
Master cylinder bracket
Master Cylinder (new GSX-R)
Stainless hardware to lace it all up.
Will come standard with fixed pegs. Folding pegs available for $40.
Made out of American made 6061-T6. Made in America, Arkansas to be more specific.
Will be approximately a four week turnaround. Have to order more bracket material. Use the same size as a set I do for a BMW, and those have just about eat everything I had on the shelf in that size. Generally takes a couple weeks to get the material in.

[J-Rod10]

Few more photos.

[ExTex]

Where in Arkansas are you located ?

Thanks

[J-Rod10]

Where in Arkansas are you located ?

Thanks

Russellville

[6]

Nice looking parts.

Not a lot of options for hawk rear sets. Cool deal.

Thanks for making and offering them here!

[Maritime]

Nice J-Rod. saw those over on DTT. If I wasn't a gimp I'd grab a set but I wouldn't be able to shift the bike with them on it LOL.

[J-Rod10]

Nice J-Rod. saw those over on DTT. If I wasn't a gimp I'd grab a set but I wouldn't be able to shift the bike with them on it LOL.

Long time, Maritime. Hope all is well!

[Maritime]

Long time, Maritime. Hope all is well!

Thanks, you too. Going to Barber this year? I hope to make it.

[J-Rod10]

Thanks, you too. Going to Barber this year? I hope to make it.

I don't know if I'm going to make it down this year. Formula 1 in Austin, and then Vegas a few weeks later. Hard to miss that much time at the shop during busy season.

[J-Rod10]

Just about wrapped up taking orders on these at the introductory price. Will take one or two more.

[eyhonda]

Nice job! I really like the indexing feature. You rarely see that available.

[6]

Nice job! I really like the indexing feature. You rarely see that available.

Had not noticed that until you pointed it out.

Very cool.

[J-Rod10]

Nice job! I really like the indexing feature. You rarely see that available.

Figure a little added adjustability never hurt no one.

[eyhonda]

Long time, Maritime. Hope all is well!

Now that Maritime mentioned it, I did have a set from my early days at DTT too. Maybe, these were made by you too?

31370857485_a0956d5ba9_c.jpg
30626099123_4759a84bba_c.jpg

[J-Rod10]

Now that Maritime mentioned it, I did have a set from my early days at DTT too. Maybe, these were made by you too?

31370857485_a0956d5ba9_c.jpg
30626099123_4759a84bba_c.jpg

Indeed they were.

That's an old one! That was back when I was knurling footpegs on the Ole Lodge & Shipley, and knocking levers out on the Bridgeport, well before I had ever touched a CNC machine.