Any recommendations are what I type o grease to use for the rolling bearings in these?
-
-
General purpose wheel bearing grease is fine.
The red kind is a little better than green.
The outside of the eccentric where it is clamped by the pinch bolt does not necessarily need grease. I run mine dry with no problems. It only needs to rotate a little when you adjust the chain tension.-I'm sorry....I did not know she was your sister.
-If Buckleys cold mixture went rancid......how would anybody know????
-Dont piss off the quiet guy with the chain saw. -
i am using CV greaseRob
88 Street Hawk
F2 tank, Aztec8 dual 4", Duc seat and CF cowl, Stage 3 jet, Uni Pods, M4 stubby, SV650 clips, controls & fuel pump, GSXR front mc and CFB1000 front caliper, F3 forks upper and internals, Penske 8983, Gino RCR, rear jump plates & R6 pegs and Vapor gauge...
04 CRF50 pit bike and stunt runner...
91 Suzuki GSF400 Bandit (she's a runner now...)
Comment
-
Cool. Thanks fellas.Comment
-
i use synthetic high temp wheel bearing grease... same stuff thats used in performance cars.
Comment
Comment