03 F4i front end

[hawaiiysr]

so another front end question. will a 03 F4i front end fit? i did a search and Doc has a '01 on his hawk so i'm guessing it should fit.

if i did go through with this front could i use a F2 wheel? how bout a hawk wheel? must i use the triples or can the tubes them selfs slide in the stock hawk triples?

thanks in advance

[nt650hawk]

WOW I GOT IN BEFORE DOC.

I don't think so.

43mm leg will not fit into a 41mm tripple hole. SOL Unless you machine it out which will leave you sell area (weaker = not good here).


I have the entire 99 F4 front on. I think you will have issues with the rotor size. and possible shimming.

It is a direct bolt on.

[Doc]

Use the F4i wheel.

[hawaiiysr]

ok talked to the guy last night. he has the complete front end. from clip ons down to the wheel. so this is a direct bolt on right? bearing size the same?

[nt650hawk]

My F4 was.

[Doc]

My F4i was.

[Stevenjhow]

yep....I did the f4i front end too.....look at this thread:

http://www.hawkgtforum.com/viewtopic.php?t=1065&highlight=f4i

I posted pics of mine while I was putting it together