I recently bought a hawk and am going through redoing the main wiring harness (bike I'm guessing was previously raced, and there are a bunch of wires cut/missing/bad splices). Problem is, I wasn't really thinking at the time and forgot to label where the wires for the CDI box, turn signal relay, and fuel pump relay came out of (e.g. for the CDI box, Y wire to top right slot, W/Y wire to top left slot, etc.) If someone could send me a picture of how the wires go in or just tell me I would really appreciate it.
-
-
Maybe the wireing diagramm helps you:
bye, M.--- memento mori --- -
I've got the shop manual with the wiring diagram. The problem is that the diagram is 2D when the CDI is 3D. The wires are stacked on top of one another. And suggestions from anyone on what to do?Comment
-
Looking into the face of the 6P plug (the side that plugs into the CDI box).
(locking tab on plug on top)
(G) (no wire) (Bl/W)
(Y/BU) (no wire) (BU/Y)Faster than your mother... She's what the pros use.Comment
-
Thanks so much. That's all I needed!Comment
-
Glad I could help.
Faster than your mother... She's what the pros use.Comment
Comment