Announcement

Collapse
No announcement yet.

what year 900rr rearsets work on a hawk gt?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    what year 900rr rearsets work on a hawk gt?

    anyone know this answer?
    Lord Squidward of FloriDUH

    #2
    '92-'96, I believe.

    -P.
    I need a bigger garage.

    It's a dirty job but someone's got to do it.

    Comment


      #3
      Why dont you get a set from Rod
      http://www.hiperform.com/rear_sets.htm
      "Life may begin at 40, but it doesn't get real interesting until about 150."

      • '88 in Candy Flair Blue + '90 in Italian Red
      • Ohlins Rear Shock
      • F2 front wheel
      • VFR750 rear wheel
      • Hiperform seat&headers
      • MSMotorsport Seat Cowl
      • Steve Lenac Tokico six pot caliper

      Comment


        #4
        i was waiting for him to get em done...then got an email about them after i posted this
        Lord Squidward of FloriDUH

        Comment


          #5
          Anyone gotten a price for the Hiperform rearsets? Website says price to be confirmed.
          -----------------------
          88 Bros
          93 Supra TT 6sp
          03 Sh*tbox Opel Combo
          -----------------------

          Comment


            #6
            Goshawk is correct. The early 900RR rearsets are what fits the hawk. Mine are the pretty Metisse type, but I notice that there are some with ball bearing movement, which I assume will allow much smoother action.

            Below is a pic

            http://whaccessories.com/RearSetsMET.jpg

            Comment


              #7
              93-95 900RR pegs will fit the Hawk

              93-95 seem to be the "right" years. They have the correct bolt hole spacing (I believe it's 78mm center-to-center) for the Hawk mounting holes. Later model 900rr rearsets went to 60mm ctc and won't work (found this out the hard way).

              Even with the 93-95, some slight adapting and creative bolting seems to be required for the brake cylinder/stop light (at least if you're retaining the Hawk ones), etc. I'm curious though: the Hawk cylinder is 1/2" I believe, and the CBR is 5/16". Would the CBR cylinder work OK with the Hawk rear caliper?

              Comment

              Working...
              X