Announcement

Collapse
No announcement yet.

Twin Headlights How do you fit them

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Twin Headlights How do you fit them

    I am swapping over to twin headlights as I streetfighter my Bros. Up front I've got a digi dash, Chrome triple, chromed Deauville forks, chrome brakes & VFR wheel.
    The problem which I hope one of you whizz kids out there can solve is how to fit them.
    The headlight bulbs are single element H3's.
    I want one headlight to be one while driving in general (daylight, night time etc) but I would like both on (high beam)when driving down country lanes etc.
    Each unit only has two cables
    Fingers crossed
    Cheers guys & Gals
    ARCIE 31
    If your not livin' on the edge your taking up too much room

    #2
    www.aztec8.com
    1988 "BlackHawk" project
    1989 "RallyHawk" is Chuck's now!
    1988 "The Gray" Tempest Gray Metallic stocker

    I can't tell you how peaceful it is. Shinya Kimura
    People who know ride Hawks. Riot

    Comment


      #3
      Here's how I wired mine. Using ~3.5" single element H3's as well. I have 2 relays under the tank. One relay is connected to the "low" light, and triggered by a "ignition on" wire, I believe I tapped into the instrument cluster illumination circuit. I then have the second relay that runs the "high" beam triggered off the high beam switch. I hope this helps, if you have some basic wiring skills it's an easy setup to do.
      Tim
      '89 HawkGT - Dirty
      '07 S3 - WHEEEEE!

      Comment

      Working...
      X