Oil pressure Switch/Sensor

[Rivvybarner]

Hello there,
I'm having to re-tap the engine casing for the oil presure switch. The previous owner smashed the original proud switch port. Question is does anyone know the correct tap I need for an original honda pressure switch? as shown. I cant seem to find the info anywhere. cant upload pic - anyone know how to resize the pic?
it says this
20211025_162218[1].jpg
Unable to resize image. Your image of 2988 x 5312 exceeds the width and height resize limits of 4608 x 4608.
cheers in advance

[ParcNHawk]

Did you take it on your cell phone?

Just open the picture on the phone and take a screenshot of that open photo. Then upload the screenshot. This can be done on the toilet with no special tools.

[Rivvybarner]

I did - and thanks for that. Will do it later when I've got it all together. cheers

[Rivvybarner]

This is the oil switch thread I need to tap the casing for.

[Rivvybarner]

sorry tried to upload pic of switch thred twice and keep getting same response on pc. wont even try on the phone.

[bitzz]

Typically M10 x 1.0

[Rivvybarner]

Thanks bitzz I'm going to get a micrometer and get it accurately measured today.

[6]

sorry tried to upload pic of switch thred twice and keep getting same response on pc. wont even try on the phone.

I'll take a look at your account and see if it's a problem on our side.

[Rivvybarner]

Cheers.

[Rivvybarner]

DSCF1856.jpg Here is the thread in question - ( had to borrow an old digital camera with not so many pixels)