So reinstalling these guys I notice they have different thread lengths either end.
10mm studs have 22mm thread with small bulge one end and 20mm thread with larger bulge the other end.
8mm studs have 18mm thread with small bulge one end and 16mm thread with larger bulge the other end.
This is definite. The Honda manua (section 11-13) shows a small diagram installed lengths of the studs but not which way round. BUT it seems to show short thread big bulge in the crankcase
Being a draughtsman I would have specified orientation on that diagram so I am unsure.
My question is what way round do I mount them? Thanks
10mm studs have 22mm thread with small bulge one end and 20mm thread with larger bulge the other end.
8mm studs have 18mm thread with small bulge one end and 16mm thread with larger bulge the other end.
This is definite. The Honda manua (section 11-13) shows a small diagram installed lengths of the studs but not which way round. BUT it seems to show short thread big bulge in the crankcase
Being a draughtsman I would have specified orientation on that diagram so I am unsure.
My question is what way round do I mount them? Thanks