Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
Nice, look into the micro switches in the push on/off lights, they go bad, are easy to change but fiddly to do. they shit the bed in my Pilot every 18...
-
I 3D printed new ones and then used plumbing ABS pipe cement. I worked ok but they were too thin so they broke over the riding season. We just printed...
Leave a comment:
-
Can't see the tank I don't think in this vid but first fire after 3 years of bike sitting with no tank as it rotted out. https://www.youtube.com/shor...
Leave a comment:
-
OP best way to try and fire the bike is to just get a small bottle and fill with fuel with a line direct to the carbs, Hang it up and let gravity feed...
- Likes 1
Leave a comment:
-
my day job is Purchasing Manger, I've been importing Aluminum and steel from China for 15 + Years, if you find the right suppliers and partner with them...
- Likes 1
Leave a comment:
-
If black I use the VHT Chassis epoxy, poor mans powder coat and tough stuff. If silver I use the Duplicolor wheel but then if doing other bits will use...
- Likes 1
Leave a comment:
-
Glad you walked away with minor stuff. Crashes can suck.
Got hit by a deer side on back in 2015. ATGATT was why I'm alive but even in full...
Leave a comment:
-
Ebay UK was tougher but this should be the same as well.
https://www.ebay.co.uk/itm/165488310...SwdW9ihR61&amd...
Leave a comment:
-
-
Just seeing this now but there should be specs on it. The important bit is 22mm - Rear facing spigot
and not vacuum. Let me check...
Leave a comment:
-
-
Electric is the way of the future. I have the eco box EV Chevy Bolt and it puts a grin on my face when I punch it. That Porsche would be epic.
- Likes 2
Leave a comment:
-
Awesome. I have a few things I wanted to do for a buddy with a vintage 67 mustang and if ASA will work I'll give it a shot. Is it smelly or toxic while...
- Likes 1
Leave a comment:
-
No but I've seen them on Youtube made of old fire extiguishers and they look fun.
- Likes 1
Leave a comment:
-
We did the same with ABS but the prints didn't hold. I think we had a heat issue. We're redoing them again and will do an acetone bath to strengthen then....
- Likes 1
Leave a comment:
-
We may relocate the filter in the loop but this was to do a POC on the location and it seemed to fill the dry carbs way faster than the factory posit...
Leave a comment:
-
No Pics but we finally got the shop to a point we could put the Hawk on the jack and get the front end in the air. After that we did 1 of the 3 needed...Last edited by Maritime; 3 Weeks Ago.
- Likes 1
Leave a comment:
-
No activity results to display
Show More
Leave a comment: