Announcement
Collapse
No announcement yet.
User Profile
Collapse
-
What does the finished appearance look like for a teflon finish?
-
I realized a long time ago there is never any way to recoup the cost of what I have spent on Hawks, and probably not the tools in my shop. I'll be happy...
- Likes 1
Leave a comment:
-
If yiou go check out home Depot they have a ZEP citrius based degreaser that comes in either a spray can, spray bottle, or gallon of concentrate. It...
- Likes 1
Leave a comment:
-
I've been doing that a lot myself recently. I picked up a new lathe and was abotu to spend money upgrading it and finally just had one of those watershed...
- Likes 1
Leave a comment:
-
I wouldn't burn a lot of time worrying about what to do until you can put eyes on it and then the solution will present itself.
- Likes 1
Leave a comment:
-
I'm pretty sure the cone on the right side has some adjustability to it and slides in and out and then probably a grub screw to keep it in place or something...
Leave a comment:
-
-
Gun metal in powder usually turns a little greyer and lighter when i have used it in the past. I don't have any photos handy from past batches....
Leave a comment:
-
Meanwhile I am tossing around the idea of this on a Hawk frame, subframe, swingarm and wheels.... Called Cadilac Grey from prismatic powders.
...
Leave a comment:
-
110 miles to a tank isn't terrible. I've experienced a few Hawks that get a little better but you gotta figure that is still around 44 mpg if you are...
Leave a comment:
-
I had that same experience in my home town last weekend. Went to a nephew's graduation and was at the wrong place across the county in another town....
Leave a comment:
-
Lowering the motor is really the same as removing it from the frame procedurally. If you want to clean it you might as well go all out, take it out and...
- Likes 1
Leave a comment:
-
-
VApor blasting is a good finish. The only thing I am unsure of over time is how long will it take to oxidize if you don't put a finish on it. From what...
- Likes 1
Leave a comment:
-
Indeed it is. Weird but it runs through the guts of the tank.
Leave a comment:
-
Yeah I guess it is too late of a warning and I should have said more as soon as you mentioned it but you really need to be wearing a respirator and gloves...
Leave a comment:
-
WEll, I guess you are at the point where you install it one way and if it doesn't line up then you install it the other way, unless someone else chimes...
Leave a comment:
-
Looks like it. Very easy to make on a lathe. Ironically I already have a plastic version I was going to print on the 3d printer in the near future....
Leave a comment:
-
WEll, set it on a table next to the OEM sprocket and that should tell you which way it goes based on which way the OEM one was supposed to.
Leave a comment:
-
And for that front, I was looking at a pdf online so not the best quality image unfortunately. It just looked very black with the cutout in the rubber...
Leave a comment:
No activity results to display
Show More
Leave a comment: